CM 12H

The Abwood CM12H utilises a high power single spindle to remove material from the bottom or top of sawn multi-crystalline blocks. This maybe used as an alternative to saw cropping of block ends where the material to be removed is minimal.

 

Features

  • Four Spindle Simultaneous Grinding for reduced cycle time
  • High pressure coolant system for maximum wheel life
  • Low cutting forces result in reduced sub-surface damage for improved wafer yield
  • Full CNC control system for ultimate machine flexibility
  • Integrated laser measuring system for in-process component inspection
  • Cost effective alternative to standard industry sawing equipment

 

High Material Removal Rates

A 15kW spindle motor coupled with a very coarse super-abrasive wheel allows for material removal rates of over 1000mm3/s. The result is that it is possible to process 10 multi-crystalline bricks per hour with removal of up to 10mm in total from the ends of the block.

 

Specification

Workpiece Material

Work Process

Maximum Workpiece Dimensions

Minimum Workpiece Dimensions

Machine Dimensions

Machine Weight

Connection Capacity

Voltage/Frequency

Compressed Air Requirement

Coolant

Approximate Capacity

CM 74

Multi Crystalline Silicon

Top/Tail Grinding

210mm x 210mm x 250mm

125mm x 125mm x 150mm

2000mm x 1500mm x 2000mm

Approx. 6000kg

17 kW

400V/50Hz; 480V/60Hz

5-7 bar

Water

180MW

Share